If you’re looking to clean the exterior of your home or business, pressure washing is a great option. It’s quick, efficient, and can get the job done right. However, if you’re not familiar with the process or how to use a pressure washer safely, you could end up causing more damage than good. In this blog post, we will discuss 4 Must-Know Tips for pressure washing that will help you get the job done right!
Tip 1: Use the Right PSI
One of the most important things to know when pressure washing is to use the right PSI, or pounds per square inch. This will ensure that you’re using enough pressure to get the job done without causing any damage. The general rule of thumb is to use a lower PSI for delicate surfaces and a higher one for tougher jobs. For example, if you’re pressure washing your deck, you’ll want to use a higher PSI than if you were cleaning your siding. Keep in mind that you can always adjust the amount of pressure depending on what you’re cleaning and how dirty it is.
Tip 2: Don’t Forget the Soap
Another important tip for pressure washing is to make sure you’re using soap. Soap will help to break down any dirt, grime, or debris that may be on your property. Without it, you’ll likely just be moving around the dirt and not actually cleaning anything.
There are a variety of pressure washing detergents on the market. You’ll want to choose one that’s specifically designed for pressure washers and that is safe for the type of surface you’re cleaning.
Tip 3: Hold the Wand at the Right Angle
When pressure washing, it’s important to hold the wand at the right angle. This will ensure that you’re delivering a powerful stream of water that can remove any tough stains or build-up. However, if you hold the wand too close to the surface or at too high of an angle, you could end up causing damage.
The best way to find the right angle is to practice on a small area first. Once you get a feel for it, you’ll be able to pressure wash your entire property with ease.
Tip 4: Be Careful of Overwashing
Finally, one of the most common mistakes people make when pressure washing is overwashing. This means that they apply too much pressure or use too much detergent, which can strip away paint or damage surfaces. If you’re not careful, you could end up causing serious damage to your property.
To avoid overwashing, start with a lower setting and increase the pressure if needed. You may also want to test a small area first to see how it reacts to the pressure washing. If you notice any damage, stop immediately and reduce the pressure.
Conclusion
By following these four simple tips, you’ll be able to pressure wash your property like a pro! Just remember to use the right PSI, don’t forget the soap, hold the wand at the right angle, and be careful of overwashing. With these tips in mind, you’ll be able to achieve amazing results.
